FTDI USB to TTL Serial Cable for Raspberry Pi - 4 Way Fixed
This FTDI USB to TTL Serial Cable for Raspberry Pi - 4 Way is compatible professional, high quality, high speed device which allows you to debug your Raspberry Pi.
It also allows you to connect your PC directly to your Raspberry Pi Serial Port.
Total length is 1.8 Meters (+/- 0.10m) and is Based on the FTDI FT232R Chipset, It has been programmed to supply up to a Maximum of 500mA on Pin 1 (+5V / VCC) (We have a 3 way version too if you do not need draw power)
All you do is plug the device in, no messing around with which header goes into which GPIO port.
One end of the cable has the header socket which connect to four pins on the Expansion/GPIO connector on the Raspberry Pi.
The cable uses the 3.3V logic levels required by the Pi and also provides +5V power to your Raspberry Pi when connected to a PC,
subject to the USB port supplying the sufficient current for your setup. (Please do not overload your Pi and up to a maximum of 500mA can be drawn)
More information in the links below.
http://elinux.org/RPi_Hardware#Power and http://elinux.org/Rpi_Low-level_peripherals
This FTDI USB to TTL Serial Cable for Raspberry Pi - 4 Way has it's I/O lines (Tx, Rx) configured to operate at 3.3V levels
This FTDI USB to TTL Serial Cable for Raspberry Pi uses a FTDI FT232R IC, which is one of the latest and most powerful USB to Serial/TTL IC on the market.
This FTDI USB to TTL Serial Cable for Raspberry Pi is made using USB 2.0 specification cable and is marked as CE & FCC & RoHS approved.
This FTDI USB to TTL Serial Cable for Raspberry Pi is 1.8M (nominal) in length with a 2.54mm (0.1") pitch header which provides access via a 4 way connector
(VCC (+5V), GND, RxD (3.3V), TxD (3.3V),)
This FTDI USB to TTL Serial Cable for Raspberry Pi - 4 Way can be used on WinCE, Windows 98 to Windows 8.1 inc 64 bit
including Windows Server 2008, 2008 R2, 2012. It also supports MAC OS 8.6+ to 10.9+ as well as Linux & Ardunio and Raspberry Pi.
Pin Out : Wire Colour : Function
1 : Red : VCC +5V typical (output)
2 : Black : Ground
3 : Yellow : TTL Receive Rx (input) - (3V3 IO)
4 : Orange : TTL Transmit Tx (output) - (3V3 IO)
Serial baud: 300 - 2764800bps (3Mbps) at TTL level depending on your end product limitations.
THIS PRODUCT IS NOT ENDORSED BY OR ASSOCIATED WITH Raspberry Pi Foundation.
All Trademarks are used for reference and are copyright of their respective owners.
USB to TTL Serial Cable FTDI chip, - 4 Way FTDI for Raspberry Pi
- Model No.: 2477
- Availability: In Stock